Chrysler Ram 2500 2012 Uživatelská příručka stáhnout pdf (Strana 10)

KEY FOB

Locking And Unlocking The Doors

• Press the LOCK button once to lock

all the doors. Press the UNLOCK

button once to unlock the driver’s

door only and twice within five

seconds to unlock all the doors.

• All doors can be programmed to

unlock on the first press of the

UNLOCK button. Refer to

Programmable Features in this

guide.

Panic Alarm

• Press the PANIC button once to turn the panic alarm on.

• Wait approximately three seconds and press the button a second time to turn

the panic alarm off.

Emergency Key

• Should the battery in the vehicle or the Key Fob transmitter go dead, there is

an emergency key located in the Key Fob that can be used for locking and

unlocking the doors. To remove the emergency key, slide the button at the top

of the Key Fob sideways with your thumb and then pull the key out with your

other hand.

CAUTION!

• If your vehicle battery becomes low or dead, your Key Fob will become

locked in the ignition.

• Do not attempt to remove the Key Fob while in this condition, damage

could occur to the Key Fob or ignition module. Only remove the

emergency key for locking and unlocking the doors.

• Leave the Key Fob in the ignition and either:

• Jump Start the vehicle.

• Charge the battery.

• Contact your dealer for assistance on how to remove the Key Fob

using the manual over ride method.

GETTING STARTED

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 147 148

Žádné komentáře

Chrysler Ram 2500 2012 Uživatelská příručka Strana 10